New machined gearbox bearing cover next to the broken original

Reverse Engineering

When a part is broken, obsolete or has no drawing, we 3D-scan or measure the old part, rebuild it as a CAD model and manufacture a new one in our workshop in Tallinn.

When reverse engineering is the answer

Broken part stopped productionA cracked cast bearing cover was 3D-scanned, rebuilt in CAD and made new in 3 days.See the case →
Original spare part too expensiveA worn pulp mill screw was 3D-scanned and remanufactured for 40% less than the original spare part.See the case →
An earlier repair failedA motor end cover that cracked after a welding repair attempt was measured and made new in 2 days.See the case →
Rotating partsA turbocharger rotor and compressor wheel were 3D-scanned during the repair.See the case →

What you get

Geometry from the part itself

The new part is made from the geometry of the original, so no drawing is needed.

A CAD model

The rebuilt model can be used for the next spare part.

One workshop

Scanning, modelling and machining in one place.

Suitable material

Class-approved materials with traceability.

How a job runs

  1. The part or photos

    Send the broken or worn part, photos or basic dimensions. Initial technical feedback usually within one business day.

  2. 3D scanning or measuring

    We 3D-scan the part or measure it.

  3. CAD model

    The geometry is rebuilt as a CAD model.

  4. Manufacturing

    The new part is machined in our workshop.

Capabilities

3D scanning
Of the old, worn or broken part
CAD model
Rebuilt from the scan or measurements
Manufacturing
CNC turning up to Ø1600 × 5000 mm →
Gears
Spur, helical and spiral bevel gears →
Materials
Class-approved materials with traceability

Send us the problem

Photos of the damage, a drawing or basic dimensions and information about where the component is installed are enough to start.

Initial technical feedback usually within one business day.

We use your details only to answer this request. Privacy Policy