Line boring both shaft axes of a winch housing

Bearing Seat Repair

Worn or oval bearing seats, misaligned bores and damaged sealing faces are built up and machined back to original geometry — in our workshop in Tallinn, or on site when the housing cannot be removed.

Typical housing problems

Worn bearing seat, lost geometryA thruster housing was set up on our horizontal boring mill; the bearing seat and housing geometry were brought back to original.See the case →
Misaligned bores, shaft axes out of lineWorn bores were built up by welding, then both axes line bored parallel, with correct gear mesh.See the case →
Damaged seat in an engine blockA camshaft bearing housing seat was milled on board, without replacing the block.See the case →
Worn seats in pump housingsSeats in fuel injection pump housings were restored instead of replacing the housings.See the case →
Worn casing surfacesWorn areas of a turbocharger casing were laser clad and machined back to original geometry.See the case →
Damaged sealing facesSealing surfaces on cylinder liners written off as scrap were restored; all seven returned to service.See the case →

How a bearing seat repair runs

  1. Photos and dimensions

    Send photos of the damage, a drawing or basic dimensions. Initial technical feedback usually within one business day.

  2. Measurement

    Bores are measured for wear, ovality and alignment.

  3. Build-up

    Worn areas are built up by laser cladding or welding.

  4. Machining

    Boring, line boring or milling back to original geometry.

Capabilities

Boring
Horizontal boring mill for housings →
Line boring
Portable line boring equipment, in the workshop or on site →
On-site milling
Portable milling equipment, set up with a dial indicator →
Laser cladding
316L, Inconel, Stellite, hard alloys →
Brush plating (nickel)
Small surfaces and minor wear, as an alternative to laser cladding

Send us the problem

Photos of the damage, a drawing or basic dimensions and information about where the component is installed are enough to start.

Initial technical feedback usually within one business day.

We use your details only to answer this request. Privacy Policy