Robotic laser cladding of an engine block with 316L in the Adretec workshop

Engine Component Repair

Worn or damaged engine blocks, cylinder heads, liners, crankshafts and fuel pump housings are restored instead of replaced — in our workshop in Tallinn, or on board when the block stays in place.

Engine block restoration on video

Engine block restoration by laser cladding and nickel coating

Engine components we restore

Engine blocks: corrosion and cavitationDamaged areas were clad with 316L stainless steel and machined back to original dimensions; six blocks restored.See the case →
Cylinder heads: damaged valve seat pocketsExhaust seat pockets on eight heads were restored with 316L; the heads were assembled and pressure-tested.See the case →
Cylinder liners: damaged sealing facesSeven Wärtsilä 46 liners written off as scrap returned to service — around €50k saved compared with new liners.See the case →
Crankshafts: suspected bent journalA Wärtsilä 32 crankshaft was checked for runout journal by journal on our large lathe.See the case →
Fuel pump housings: worn seatsSeats in eight housings were restored instead of buying new housings.See the case →
Camshaft bearing seat damaged in the blockThe seat was milled on board with portable milling equipment; the block was not replaced.See the case →
Turbochargers: damaged casing and rotorCasing geometry restored, rotor repaired, 3D-scanned and balanced.See the case →

How an engine component repair runs

  1. Photos and dimensions

    Send photos of the damage, a drawing or basic dimensions. Initial technical feedback usually within one business day.

  2. Inspection and measurement

    Wear, damage and runout are measured to decide what can be restored.

  3. Restoration

    Laser cladding with 316L or another alloy, welding, or milling on board.

  4. Machining and checks

    Machined back to original dimensions; cylinder heads can be pressure-tested before delivery.

Send us the problem

Photos of the damage, a drawing or basic dimensions and information about where the component is installed are enough to start.

Initial technical feedback usually within one business day.

We use your details only to answer this request. Privacy Policy