
Shaft & Journal Repair
Worn bearing journals, seal areas and worn diameters are rebuilt by laser cladding and machined back to original dimensions — in our workshop in Tallinn, or on site when the rotor cannot be moved.
Typical shaft problems
How a shaft repair runs
Photos and dimensions
Send photos of the damage, a drawing or basic dimensions. Initial technical feedback usually within one business day.
Measurement
Journals are measured for wear and runout.
Laser cladding
The worn diameter is built up with a suitable alloy.
Machining and balancing
Machined back to original dimensions; rotors can be dynamically balanced up to 700 kg.
Capabilities
- In the workshop
- CNC turning up to Ø1600 × 5000 mm →
- Brush plating (nickel)
- Small surfaces and minor wear, as an alternative to laser cladding
- Dynamic balancing
- Up to 700 kg
- Piston rods
- Up to Ø400 × 4800 mm
Shaft repair: completed works

11 MW motor rotor
Worn bearing journal on an 11 MW electric motor rotor
11 MW Motor rating

Motor rotor shaft
Worn journal on an electric motor rotor shaft

Electric machine rotor
Worn bearing seats on an electric machine rotor
2 days Back to assembly

Wärtsilä 32 crankshaft
Suspected bent journal on a Wärtsilä 32 crankshaft

Hydraulic cylinders
Hydraulic cylinders requiring repair or new manufacture
Ø400 mm Max diameter
Send us the problem
Photos of the damage, a drawing or basic dimensions and information about where the component is installed are enough to start.
Initial technical feedback usually within one business day.