
Power Generation
Rotors, shafts, housings and rotating equipment where dimensional accuracy and minimum downtime are critical.
Typical power generation repairs
How a job runs
Photos and dimensions
Send photos of the damage, a drawing or basic dimensions. Initial technical feedback usually within one business day.
Repair plan
We decide whether to repair, restore, reverse engineer or manufacture the part.
Workshop or on site
The work is done in our workshop in Tallinn or where the equipment is installed.
Back in service
The part is machined to size and returned.
Power generation: completed works

Electric machine rotor
Worn bearing seats on an electric machine rotor
2 days Back to assembly

Gearbox gears
Gears and pinion shafts needed for gearbox replacement

Motor rotor shaft
Worn journal on an electric motor rotor shaft

Cylinder heads
Damaged exhaust valve seat pockets on 8 cylinder heads
8 Cylinder heads

ABB turbocharger casing
ABB turbocharger casing with worn surfaces and lost geometry

Fuel pump housings
Worn seats in fuel injection pump housings
8 Housings restored

11 MW motor rotor
Worn bearing journal on an 11 MW electric motor rotor
11 MW Motor rating

Wärtsilä 46 cylinder liners
Seven Wärtsilä 46 cylinder liners written off as scrap
7 Liners saved from scrap

Engine blocks
Engine block worn beyond service limits
6 Engine blocks restored

Wärtsilä 32 crankshaft
Suspected bent journal on a Wärtsilä 32 crankshaft

Gearbox bearing cover
Broken gearbox bearing cover stopped production — no spare available
3 days From broken part to new cover

Electric motor end cover
Motor end cover, which is also the brake disc, cracked after a failed welding repair
2 days New cover manufactured

Hydraulic cylinders
Hydraulic cylinders requiring repair or new manufacture
Ø400 mm Max diameter
Send us the problem
Photos of the damage, a drawing or basic dimensions and information about where the component is installed are enough to start.
Initial technical feedback usually within one business day.