Laser cladding of a bearing journal on an 11 MW motor rotor on site

On-Site Repair

The part can’t be removed? We bring the repair to it: on-site machining and on-site laser cladding. When on-site work is not enough, the part goes to our workshop in Tallinn.

On-site repair on video

On-site laser cladding of a ferry generator rotor journal
Laser cladding of a damaged bearing journal on site — before and after

When the part can’t be removed

Too large or heavy to transportAn 11 MW motor rotor journal was clad and machined at the customer’s facility in under 18 hours.See the case →
On boardEngine and machinery components are repaired on board — for example, a camshaft bearing seat milled in the engine block.See the case →
Dismantling would take too longWorking on site avoids dismantling the equipment and shortens the time it is out of service.
Removed on board, repaired in the workshopWhen on-site work is not enough, we remove the component on board and repair it in Tallinn.See the case →

How an on-site job runs

  1. Equipment and location

    Send photos, dimensions and where the equipment is installed. Initial technical feedback usually within one business day.

  2. Repair plan

    We define what is done on site and what, if anything, goes to the workshop.

  3. Work on site

    Machining or laser cladding at your facility or on board.

  4. Workshop when needed

    If on-site work is not enough, the component is removed and repaired in our workshop in Tallinn.

Send us the problem

Photos of the damage, a drawing or basic dimensions and information about where the component is installed are enough to start.

Initial technical feedback usually within one business day.

We use your details only to answer this request. Privacy Policy